Magnetic Circuits Problems And Solutions Pdf May 2026

Flux density in yokes = same as center limb area? Yokes have (A=6\ \textcm^2), but they carry (\Phi_c)? No – yokes carry the outer branch flux? Actually each yoke segment carries (\Phi_o) if symmetric. Check: At top yoke, flux from center splits: half to left outer, half to right outer. So yoke carries (\Phi_o). [ B_yoke = \frac0.4845\times 10^-36\times 10^-4 = 0.8075 \ \textT ] Desired flux (\Phi_des = 1.2 \ \textmWb) with (NI = 250 \ \textA-turns) (since (0.5 \times 500)).

Hint: By symmetry, the two outer limbs carry equal flux. A DC relay has a magnetic circuit that should produce (\Phi = 1.2 \ \textmWb) at (I = 0.5 \ \textA) with (N = 500). After years of use, the measured flux is only (0.8 \ \textmWb) at the same current. You suspect an unexpected air gap has developed (e.g., due to corrosion or mechanical wear).

MMF: (\mathcalF = NI = 200 \times 2 = 400 \ \textA-turns) [ \Phi = \frac\mathcalF\mathcalR_c = \frac400398 \times 10^3 \approx 1.005 \ \textmWb ] magnetic circuits problems and solutions pdf

Given: After fault, (\Phi_actual = 0.8\ \textmWb) at (NI=250). So total reluctance = (250 / 0.8\times10^-3 = 312.5 \ \textkA-t/Wb). Core reluctance alone = (497.4 \ \textkA-t/Wb). If total reluctance is lower than iron alone, that’s impossible. Therefore: The original core for design purposes. The fault increased the gap.

Percent change from Problem 2: [ \frac0.232 - 0.2010.201 \times 100 \approx +15.4% ] Fringing reduces reluctance → increases flux. Ignoring fringing underestimates performance. Solution 4 – Series-Parallel Circuit Step 1 – Reluctances (all (\mu = 1000 \mu_0)) Flux density in yokes = same as center limb area

The center limb carries (\Phi_c). That flux splits into two paths, each with total reluctance (\mathcalR_branch = \mathcalR_o + 2\mathcalR_y). The center limb reluctance is in series with the parallel combination of the two branch reluctances.

Let’s find gap length that gives (\mathcalR total = 312.5\ \textkA-t/Wb): [ \mathcalR g = \mathcalR total - \mathcalR iron = 312.5 - 497.4 = -184.9 \ \text(negative → impossible) ] Conclusion: The core is saturating or the permeability has dropped. A better problem would give (\Phi_healthy) first. Actually each yoke segment carries (\Phi_o) if symmetric

Let’s correct the fault diagnosis realistically: