I notice you asked for a about the iMAX B6AC v2 firmware update , rather than the technical steps. So here’s a short, fictional tale for you: The Ghost in the Charger
But he never updates firmware again. If you actually need the firmware update instructions for the iMAX B6AC v2 (hardware version check, USBasp method, and avoiding bricking), just say the word — I’ll switch from storytelling to tech support. imax b6ac v2 firmware update
He searched online. Buried on a German RC forum (page 4, after ten “just buy a new one” replies), a user named LipoSavage_77 wrote: “v2 firmware 1.13 fixes the voltage sense bug. Flash at your own risk.” I notice you asked for a about the
Marco’s iMAX B6AC v2 had been flawless for two years—until it wasn’t. One Tuesday, it started beeping at 4.2V per cell as if 4.19V was an insult. Then the calibration drifted: a 5000mAh pack charged to “4782mAh” and stopped. His drones felt it first—shorter flights, uneven cell voltages after storage. He searched online
He tested a 3S LiPo. Charged dead-straight to 12.60V. IR readings appeared—precise to 0.1mΩ. His old packs suddenly behaved again. He posted on the forum: “It worked. But the charger now shows ‘Build: private’ at boot.”